TM 11-5965-283-20P
SECTION I
INTRODUCTION
1. Scope
Code
Definition
This manual lists spares and repair parts; special
PA - Item procured and stocked for anticipated or
tools: special test, measurement, and diagnostic
known usage.
equipment (TMDE), and other special support
XD - A support item that is not stocked. When
equipment
required for performance of
required, item will be procured through
organizational maintenance of the H-182/PT. It
normal supply channels.
authorizes the requisitioning and issue of spares and
NOTE
repair parts as indicated by the source and
Cannibalization or salvage maybe
maintenance codes.
used as a source of supply for any
2. General
items source coded above except
those coded XA and aircraft sup-
This Repair Parts and Special Tools list is divided
port items as restricted by AR 700-
into the following sections
42.
(2) Maintenance code. Maintenance codes are
and repair parts authorized for use in the perfor-
assigned to indicate the levels of maintenance
mance of maintenance. The list also includes parts
authorized to USE and REPAIR support items. The
which must be removed for replacement of the
maintenance codes are entered in the third and
authorized parts. Parts lists are composed of func-
fourth positions of the Uniform SMR Code format as
tional groups in numeric sequence, with the parts in
follows:
each group listed in figure and item number
(a) The maintenance code entered in the third
sequence.
position will indicate the lowest maintenance level
b. Section III. Special Tools List. Not applicable.
authorized to remove, replace, and use the support
item. The maintenance code entered in the third
Number Index. A list, in National item identifica-
position will indicate one of the following levels of
tion number (NIIN) sequence, of all National stock
maintenance:
numbers (NSN) appearing in the listings, followed
by a list, in alphameric sequence, of all part
Application-Explanation
Code
numbers appearing in the listings. National stock
O - Support item is removed, replaced, used at
numbers and part numbers are cross-referenced to
the organizational level.
each i l l u s t r a t i o n figure and item number
(b) The maintenance code entered in the
appearance.
fourth position indicates whether the item is to be
3. Explanation of Columns
repaired and identifies the lowest maintenance level
with the capability to perform complete repair (i.e.,
a. Illustration. This column is dirided as follows:
all authorized maintenance functions). This position
(1) Figure number. Indicates the figure number
will contain one of the following maintenance codes:
of the illustration on which the item is shown.
(2) Item number. The number used to identify
item called out in the illustration.
Z - Nonrepairable. No repair is authorized.
b. Source, Maintenance, and Recoverability (SMp)
(3) Recoverability code. Recoverability codes are
Codes.
assigned to support items to indicate the disposition
(1) Source code. Source codes indicate the
action on unserviceable items. The recoverability
manner o f a c q u i r i n g support i t e m s f o r
code is entered in the fifth position of the Uniform
maintenance, repair, or overhaul of end items.
SMR Code format as follows:
Source codes are entered in the first and second
Recoverability
positions of the Uniform SMR Code format as
follows:
1