TM 32-5835-001-24 & P
Action
Remarks
Item
3. Front panel
Move from
Movement is limi-
3A3 (7)
chassis as far
ted by length of
as possible.
wiring harness.
Check for damage to
knobs and cracks in
rubber switch covers.
Make sure that clear
plastic on meter face
and counter can be seen
through. Check for
accumulation of dirt
and grease.
Front panel
Clean using cleaning
3A3 (7)
compound and soft brush.
1. Front panel
Repair by replacing
Spanner wrench
-
3A3
defective parts.
is required for
replacing meter.
2. Front panel
Position onto chassis.
3A3 (7)
3. 4 screws (4), lock
Install, but do not
washers (5), and
tighten.
flat washers (6)
1. Front panel
Align front panel to mode
3A3 (7)
selector using alignment
bushing tool. Place align-
ment bushing tool through
front panel and over mode
selector shaft (8). Tighten
four captive screws (4) to
secure front panel to trans-
port frame. Remove align-
ment bushing tool.
Install
2. Knob 3A3A1 (3),
retainer ( 2), and
screw (1)
3-94