TM 32-5835-005-14 & P
Section
IV.
INSTALLATION
INSTRUCTIONS
b. Rack Mounted Operating Configuration.
For ac or dc operation the recorder may
be rack mounted (using panel extenders/
As noted in the siting instructions,
hardware provided) and connected either
in either of two modes. Except for the
to a 115 or 230 VAC or 22-30 VDC power
source using power cable. Refer to
difference in use of a shock mount or
rack panel extenders, the operating pro-
cedure is the same in any case. Using
ing dimensions.
applicable portions of the installation
c. Signal Connections. Five jacks are
instructions, prepare the recorder for
either vehicle/aircraft or rack mounted
operation. Connect the proper input
of the recorder.) To connect headphones,
signal source, the headphone, and the
lift jack cover and insert applicable
microphone.
plug into proper jack by pushing
straight in until firmly seated. The
AUDIO and FOOTSWITCH connectors on
the rear of the unit may also be used.
a. Vehicle/Aircraft Mounting. To per-
mit operation of the unit in a vehicle
or aircraft, a mounting base is provided
to support the recorder. Install the
2-8. External Connections.
recorder as follows:
Power Input Connections. Connectors on
all three power cables are polarized so
(1) Slide unit into shock mounnt
that power supply ends of cables will
(refer to Figure 2-1,)and position so
mate with power input connector A4J1
that the two (2) pins on rear of the
in only one position. The connector
shock mount fit into the two (2) match-
for the power source end of the 230 VAC
ing holes on the rear of the unit.
and 28 VDC is selected (and installed)
NOTE
by the user to mate with the applic-
able power source. Connect cables to
the unit as follows:
Prior to fastening unit to mount, be
certain that connector cap chains on
a. Select the proper power cables
the rear of the unit are clear of mount.
to use with the available power.
(2) Engage lower flange of the re-
b. Connect the appropriate power
corder front panel with mount clamp and
cable to POWER input connector A4J1
secure with knurled clamp fasteners.
by rotating cable connector until it
NOTE
partially seats inside the power input
connector. Turn the knurled ring on
Installation of the vibration isolator
cable connector until connectors are
drawn together and seat securely.
(vehicular/aircraft mount) is beyond
the scope of this manual. Refer to
c. Connect opposite end of applic-
able power cable to appropriate power
ing dimensions.
source.
2-2