TM 11-5835-241-13&P
represents the average time required to restore an item (assembly, sub-
assembly, component, module, end item or system) to a serviceable condition
This time includes preparation
under typical field operating conditions.
time, troubleshooting time and quality assurance/quality control time in
addition to the time required to perform the specific tasks identified for
the maintenance functions authorized in the maintenance allocation chart.
Subcolumns of column 4 are as follows:
C - Operator/Crew
O - Organizational
F - Direct Support
H - General Support
D - Depot
Column 5 specifies by code, those
e. Column 5, Tools and Equipment.
common tool sets (not individual tools) and special tools, test, and sup-
port equipment required to perform the designated function.
Tool and Test Equipment Requirements (Table 1).
C-4 .
a.
Tool or Test Equipment Reference Code. The numbers in this column
coincide with the numbers used in the tools and equipment column of the MAC.
The numbers indicate the applicable tool or test equipment for the mainte-
nance
functions.
b.
Maintenance Category. The codes in this column indicate the mainte-
nance category allocated the tool or test equipment.
c.
Nomenclature. This column lists the noun name and nomenclature of
the tools and test equipment required to perform the maintenance functions.
C-4
Previous Page
