APPENDIX D
GENERAL SUPPORT, MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
Code
Explanation
D-1.
Scope
P2 -
Repair parts which are procured and stocked
This appendix lists repair parts and special tools
for insurance purposes because the combat
required for the performance of direct support, general
or military essentiality of the end item
support, and depot maintenance of the Headset-
dictates that a minimum quantity be
Microphone 19LB-87.
available in the supply system.
D-2.
General
P9
-
Assigned to items which are NSA design
This Repair Parts and Special Tools List is divided into
controlled: unique repair parts, special tools,
the following sections:
test, measuring and diagnostic equipment,
which are stocked and supplied by the Army
parts authorized for the performance of maintenance at
COMSEC logistic system, and which are not
the direct support, general support, and depot level.
subject to the provisions of AR 380-41.
b. Special Tools, Test and Support Equipment
P10 -
Assigned to items which are NSA design
- Section III. Not applicable.
controlled: special tools, test, measuring
c. Index - Federal Stock Number Cross-
and diagnostic equipment for COMSEC
Reference to Figure and Item Number or Reference
support, which are accountable under the
provisions of AR 380-41, and which are
numbers in ascending numerical sequence followed by
stocked and supplied by the Army COMSEC
a list of reference numbers in ascending alpha-numeric
logistic system.
sequence, cross-referenced to illustration figure number
M
-
Repair parts which are not procured or
and item number.
stocked, but are to be manufactured in
d. Index - Reference Designation Cross-
indicated maintenance levels.
Reference to Page Numbers - Section V.
Not
A
-
Assemblies which are not procured or
applicable.
stocked as such, but are made up of two or
more units. Such component units carry
D-3.
Explanation of Columns
individual stock numbers and descriptions,
The following provides an explanation of columns in the
are procured and stocked separately, and
tabular lists.
can be assembled to form the required
a. Source, Maintenance, and Recoverability
assembly
at
indicated
maintenance
Codes (SMR), Column 1:
categories.
(1) Source code indicates the selection
X
-
Parts and assemblies which are not procured
status and source for the listed item. Source codes
or stocked and the mortality of which
used are -
normally is below that of the applicable end
Code
Explanation
item or component. The failure of such part
P
-
Repair parts which are stocked in or supplied
or assembly should result in retirement of
from the GSA/DSA, or Army supply system,
the end item from the supply system.
and authorized for use at indicated
X1
-
Repair parts which are not procured or
maintenance categories.
stocked. The requirement for such items
will be filled by use of the next higher
assembly or component.
18
Previous Page
