TM 32-5835-005-14 & P
the "work time" figure represents the
not normally return an item to like
average time required to restore an
new condition.
item assembly, subassembly, component,
Consists of those
k. Rebuild.
module, end item, or system) to a ser-
viceable condition under typical field
services/actions necessary for the
operating conditions. This time in-
restoration of unserviceable equip-
cludes preparation time, trouble-
ment to a like new condition in
shooting time, and quality assurance/
accordance with original manufacturing
standards. Rebuild is the highest
quality control time in addition to the
time required to perform the specific
degree of materiel maintenance applied
tasks identified for the maintenance
to Army equipment. The rebuild opera-
functions authorized in the maintenance
tion includes the act of returning to
allocation chart. The symbol designa-
zero those age measurements (hours/
tions for the various maintenance
miles, etc.) considered in classifying
levels are as follows:
Army equipments/components.
C . . . . . . . . . . . . . . . . . . . Operator or crew.
B-3. EXPLANATION OF COLUMNS IN THE
O . . . . . . . . . . . Organization maintenance.
MAC, SECTION II.
F . . . . . . . . . Direct support maintenance.
a. Column 1, Group Number.
H . . . . . . . . General support maintenance.
D . . . . . . . . . . . . . . . . . . Depot maintenance.
Column 1 lists group numbers, the
purpose of which is to identify com-
e. Column 5, Tools and Equipment.
ponents, assemblies, subassemblies,
Column 5 specifies, by code, those
and modules with the next higher
common tool sets (not individual tools)
assembly.
and special tools, TMDE, and support
b. Column 2, Component/Assembly.
equipment required to perform the
designated function.
Column 2 contains the names of com-
ponents, assemblies, subassemblies,
f. Column 6, Remarks. This
and modules for which maintenance
is authorized.
column shall, when applicable, contain
a letter code, in alphabetic order,
c. Column 3, Maintenance
which shall be keyed to the remarks
Functions. Column 3 lists the
contained in Section IV.
functions to be performed on the
B-4. EXPLANATION OF COLUMNS IN TOOL
item listed in column 2. (For
detailed explanation of these
AND TEST EQUIPMENT REQUIREMENTS.
functions, see para. B-2.)
SECTION II.
d. Column 4, Maintenance
a. Column 1, Reference Code. The
Level. Column 4 specifies, by the
tool and TMDE reference code correlates
listing of a "work time" figure in
with a code used in the MAC, Section
the appropriate sub-column(s), the
II, Column 5.
lowest level of maintenance
b. Column 2, Maintenance Level.
authorized to perform the function
listed in column 3. This figure
The lowest level of maintenance
represents the active time required
authorized to use the tool or test
to perform the maintenance function
equipment.
at the indicated level of maintenance.
If the number or complexity of the
c. Column 3, Nomenclature. Name
tasks within the listed maintenance
or identification of the tool or test
function vary at different maintenance
equipment.
levels, appropriate "work time"
figures will be shown for each level.
The number of manhours specified by
B-2
Previous Page
