TM 11-5965-231-14P
SECTION I.
INTRODUCTION
1-1. Scope
(1) Source code. Indicates the source
f o r the listed items. Source codes are -
This manual lists basic issue items, items
Code
Explanation
troop installed or authorized, repair parts,
P-
Repair parts, special tools and test
a n d special tools required by the crew/
equipment supplied from the GSA/
operator for operation and required for the
DSA or Army supply system and
performance of organizational, direct sup-
a u t h o r i z e d for use at indicated
port, general support, and depot mainte-
maintenance categories.
nance of the H-113/U. The PCCN for the
P2-
Repair parts, special tools and test
H-113/U is GCMAAY for all models.
equipment which are procured and
1-2. General
b e c a u s e the combat or military
This basic issue items, items troop in-
essentiality of the end item dic-
s t a l l e d or authorized, repair parts, and
tates that a minimum quantity be
special tools list is divided into the follow-
available in the supply system.
ing sections -
P9-
Assigned to items which are NSA
a. Basic Issue Items - Section II. N o t
design controlled: unique repair
applicable.
p a r t s , special tools; test, mea-
b . Items Troop Installed or Authorized
suring, and diagnostic equipment
List - Section III. Not applicable.
which are stocked and supplied by
c. Prescribed Load Allowance (PLA) -
the Army COMSEC Logistic Sys-
Section IV. Not applicable.
tem and which are not subject to
d. Repair Parts List - Section V. N o t
the provisions of AR 380-41.
applicable.
P10-
Assigned to items which are NSA
e. Special Tools, Test and Support Equip -
d e s i g n controlled: special tools,
ment - Section VI. Not applicable.
t e s t , measuring, and diagnostic
equipment for COMSEC support
of repair parts authorized for the perform-
which are accountable under the
ance of maintenance at the direct support,
provisions of AR 380-41 and which
general support, and depot level.
are stocked and supplied by the
g. Special Tools, Test and Support Equip-
Army COMSEC Logistic System.
ment - Section VIII. Not applicable.
M-
Repair parts, special tools and test
h. Index - F e d e r a l Stock Number and
equipment which are not procured
Reference Number Cross-Reference to
or stocked as such in the supply
system but are to be manufactured
l i s t , in ascending numerical sequence, of
at indicated maintenance levels.
all Federal stock numbers appearing in the
A-
Assemblies which are not procured
listings, followed by a list, in alphameric
or stocked as such but are made
sequence, of all reference numbers appear-
u p of two or more units. Such
ing in the listings. Federal stock number
component units carry individual
and reference numbers are cross- refer -
stock numbers and descriptions,
enced to each illustration figure and item
a r e procured and stocked sep-
n u m b e r or reference designation appear-
arately, and can be assembled to
ance.
form the required assembly at
indicated maintenance categories.
1-3. Explanation of Columns
X-
Parts and assemblies that are not
The following provides an explanation of
procured or stocked because the
columns found in the tabular list.
failure rate is normally below that
a. Source, Maintenance, and Recover-
of the applicable end item or com-
ability Codes (SMR).
ponent. The failure of such part
1