TM 32-5835-001-24 & P
Remarks
Action
Item
1.
Power Supply (4)
Retain
4 screws (1), lock
Remove
washers (2), and
flat washers (3)
Items are connected by wiring
2.
Power Supply (4)
Slide out of case (9)
harness.
as far as it will go.
Check for evidence
of overheating
(charred components),
for physical damage to
cards 2A1 and 2A2
(such as fractured
cards or open printed
wiring), and for accum-
ulation of dust and dirt.
Check gasket for dirt,
damage, or breaks.
Clean using a soft brush
Power supply (4)
or compressed air.
Figure FO-1
Power supply (4)
Repair by replacing
defective piece parts.
Replace 2A1 or 2A2 only
if cards are fractured,
charred, or have open
printed circuit wiring.
Replace transistor 2Q1( 5).
Replace gasket by digging
out defective gasket. Clean
out gasket groove with
toluene. Secure new gasket
with CHO-BOND 1029 (Mfd
by Chromerics, Inc.,
Woburn, Mass.).
3-75
Previous Page
