TM 32-5835-001-24 & P
Code
Definition
AD
Item to be assembled at depot maintenance level.
XA
Item is not procured or stocked because the requirements for the
item will result in the replacement of the next higher assembly.
XB
Item is not procured or stocked. If not available through
salvage, requisition.
xc
Installation drawing, diagram, instruction sheet, field service
drawing, that is identified by manufacturer's part number.
XD
A support item that is not stocked. When required, item will be
procured through normal supply channels.
NOTE
Cannibalization or salvage may be used as a source of supply for any items
coded above except those coded XA and aircraft support items as restricted
by AR 700-42.
(2) Maintenance Code. Maintenance codes are assigned to indicate the levels of
maintenance authorized to USE and REPAIR support items. The maintenance codes
are entered in the third and fourth positions of the Uniform SMR Code format as
follows:
(a) The maintenance code entered in the third position will indicate the lowest
maintenance level authorized to remove, replace, and use the support item. The
maintenance code entered in the third position will indicate one of the following levels
of maintenance:
Code
Application/Explanation
C
Crew or operator maintenance performed within organizational
maintenance.
Support item is removed, replaced, used at the organizational
O
level.
F
Support item is removed, replaced, used at the direct support
level.
H
Support item is removed, replaced, used at the general support
level.
D
Support items that are removed, replaced, used at depot, mobile
depot, or specialized repair activity only.
(b) The maintenance code entered in the fourth position indicates whether the
item is to be repaired and identifies the lowest maintenance level with the capability
to perform complete repair (i. e., all authorized maintenance functions). This position
will contain one of the following maintenance codes.
C-3
Previous Page
