TM 32-5835-005-14 & P
(b) Using a 5/64" Allen wrench, set
eccentric cams such that Record/Repro-
duce head is flush with the roller face
line (See Figure 8-3. a and b) and
template.
(c) Use care in setting cams as im-
proper adjustment will jam the slide
assembly.
(d) Using opposite side of template,
set kick plate to record head distance.
Use a #1 Phillips screwdriver. (See
(e) Set slide plate solenoid linkage
for about 1/64" over travel of slide
past roller contact with capstan.
Solenoid may be electrically activated
or held in with finger pressure.
(f) Holding slide plate solenoid in,
set spring pressure such that 1 lbs.
just lifts roller from capstan. Use
a .050" Allen wrench. (See Figure 8-5.)
(g) Repeat paragraph 8-18., steps s
through x.
8-33.
Items to be Inspected.
Unit shall be inspected as per Table
8-4, on page 8-17.
8-19
Previous Page
