TM 11-5835-241-13&P
the 90 degree position, slide it to the rear to separate the separable
hinges, and remove the top cover.
Remove the microphone and attach-
ment cord from the storage compartment and uncoil the power cord.
Plug the power cord into a 115V ac outlet.
a.
NOTE
The frequency of the ac power source must be
either 50 Hz or 60 Hz.
Two capstan drive
pulleys are supplied with the recorder, one
for the 50 Hz and one for 60 Hz.
In these
operating procedures it is assumed that the
correct capstan drive pulley has been installed
Depress the POWER ON-STOP switch and note that the power on
b.
indicator lamp lights.
If the lamp does not light, check fuses F1
and F2.
If necessary, replace fuses with same type and rating.
Place a full reel of tape on the feed (left) reel pedestal.
c.
Place an empty reel on the takeup (right) reel pedestal.
d.
If end of tape is
e. Unwind approximately 18 inches of tape.
secured on the reel with an adhesive, cut this portion off to prevent
the possibility of adhesive getting on the head or capstan.
Route the tape (as indicated by black line on the top panel)
f.
over the tape guide stud and face of recorder-reproducer-erase head,
between the capstan and capstan pressure roller, and onto the hub
Wind three or four turns onto the
slot on the empty takeup reel.
takeup reel.
Set the speed control to the desired recording speed. Press
g.
the speed control to the down position for 3-3/4 inches per second
(i.p.s.) or pull the speed control to the up position for 7-1/2 i.p.s.
3-4
Previous Page
