TM 32-5835-001-24 & P
formed on the power supply after any repairs are made. This test is performed with
the equipment completely assembled.
a. Equipment.
(1) DC Source
(2) Multimeter
(3) Variac
(4) Oscilloscope
(5) 230 Vac Cable
(6) 117 Vac Cable
(7) 22 to 30 Vac Cable
(8) Test Cable TX-2
(9) Load Resistor TX-9
WARNING
HIGH VOLTAGE is used in the operation of this equipment. DEATH
ON CONTACT may result if personnel fail to observe safety precau-
tions. Learn the areas containing high voltage in your equipment. Be
careful not to make contact with high voltage connections when testing
this equipment.
CAUTION
To avoid damage to your equipment be sure the dc source and
variac output adjustment controls are set fully counterclock-
wise before use.
b. Procedure.
(1) Connect equipment as shown in figure 3-24.
(2) Perform test procedure listed in table 3-11.
3-82
Previous Page
