TM 32-5835-005-14 & P
(f) Bearings may be removed easily
(j) Replace clips with special tool,
Waldes S1520. Allow enough clearance
with needle nose pliers.
for pulley and shaft to turn without
undue end shake of capstan shaft.
(g) Reassembly is the reverse of dis-
assembly.
(k) Replace Mylar belt, using pro-
cedure of paragraph 8-18, steps 1
(h) It will be necessary to set up
the brake adjustment. (See paragraph
through x.
8-30).
8-24. Capstan Replacement.
Motor Removal.
(a) Repeat paragraph 8-18, steps a
(a) Repeat paragraph 8-18, steps a
through g.
through j.
(b) Capstan shafts are the same dia-
(b) Remove strobe disc, using .050"
meter, the pulleys are not.
Allen wrench.
(1) The capstan pulley on the
(c) Remove rubber reel belts, using
supply reel side is part no. 0149-1-
procedure of paragraph 8-19, steps
3070-2.
b through i.
(2) The capstan pulley on the
(d) Remove four (4) screws, using
take-up reel side is part no. 0149-1-
#1 Phillips screwdriver.
3070-1.
(e) Pull the three (3) motor assembly
(c) Remove Mylar
belt.
free of transport, using service loop
provided. Snip any plastic cable
(d) Holding a pulley with fingers,
ties that interfere with procedure.
unscrew hex head screw with .050"
(f) Remove defective motor by un-
Allen wrench. Remove pulley.
screwing three (3) screws with #0
Phillips screwdriver.
(e) With special tool, Waldes part
no. S1520, remove two (2) grip clips
(g) Replace defective motor(s).
from shaft.
(f) Remove shaft and locating pin.
(h) Replace three (3) motor assembly
Note that capstan associated with the
screws and replace any damaged plastic
take-up reel requires that the solenoid
cable ties.
be removed. Unscrew solenoid, do not
disturb linkage or its adjustments.
(i) Replace strobe disc.
(g) Bearings may be knocked out using
(j) Refer to paragraph 8-18, steps
a 1/16" Allen screwdriver. DO NOT USE
k through r for replacement of Mylar
THE CAPSTAN SHAFTS TO KNOCK OUT BEAR-
belt.
INGS.
(k) Refer to paragraph 8-19, steps
(h) Replace bearings and/or shaft
j through n for replacement of rubber
whichever was indicated. Reinsert
reel drive belt.
locating pin.
(i) Replace pulley with hex head
screw, lock washer and washer.
8-13
Previous Page
