TM 32-5835-005-14 & P
(a) To set reel brakes, tighten stop
8-26. Repair of Control Panel Assembly.
Repair of control panel assembly con-
turns brake rim. (Slowly turn three (3)
sists of replacement of malfunctioning
cornered reel collet with fingers).
parts. Repair as follows:
(b) Back off a quarter turn with nut
(a) Replacement of most parts is
driver until brake holds.
obvious and no specific instructions
8-31. Replacement of Reel Drive Collets.
wiring information.
It is not necessary to remove transport
(b) If counter window requires re-
from chassis/panel assembly.
placement, coat edges with Type II
adhesive per ME-A-8623 prior to
(a) To replace plastic collets, use a
installing.
3/16" blade screwdriver to unscrew cap
screws.
8-27. Counter Reset Adjustment.
(b) Replace damaged collets.
If reset push rod is binding loosen
counter mounting screws with a #1
(c) Replace screws, using a medium
Phillips screwdriver and reposition
grade thread locking compound.
counter as required to obtain proper
operation.
8-31. Removal of Rubber Pinch Rollers.
assembly.
through g.
(b) Remove pin support brackets'
of replacement of A1V1 phototransistor
two (2) screws, using a #0 Phillips screw-
assembly or optical disc as required.
8-29. Repair of End-Of-Tape Sensor
(c) Remove Allen adjustment screws and
Assembly.
springs, using a .050" Allen wrench.
Repair of End-Of-Tape sensor consists
(d) Remove roller arm assemblies.
of replacement A1V2 phototransistor
assembly.
(e) Replace new roller arm assemblies,
pins and bracket.
8-30. Reel Brake Adjustment.
(f) Replace slide assembly and all
If braking action is inadequate, ad-
screws.
just brakes as follows: Note: This pro-
cedure does not require the transport
(g) Adjustment will be required,
to be removed from the chassis/panel
assembly.
8-32. Adjustment of
Pinch Rollers.
(a) To adjust pinch rollers, trans-
port must be removed from chassis/panel
through f. Ignore these steps if trans-
port is already removed.
8-14