TM 11-5835-241-13&P
assembly from bottom of chassis.
e.
To replace counter, place counter in position from bottom
of chassis and attach using two screws removed in d above.
Use flat
head screw nearest front of chassis (near VU meter) to prevent inter-
ference with meter.
Replace meter terminal strip on flat head screw and secure
f.
using lockwasher and nut removed in step c.
Reinstall W meter.
g.
Slip counter drive belt over counter drive pulley. Make
h.
sure belt is in grooves of pulleys on motor shaft and counter.
i.
Reinstall top panel and replace chassis in case.
REMOVAL AND REPLACEMENT OF OPERATE SWITCH ASSEMBLY.
Remove chassis from case (Paragraph 4-3) and remove top panel from
chassis (Paragraph 5-4) to gain access to parts.
a.
Remove three screws which secure chassis end plate to mechan-
ical chassis and fan end plate away from mechanical chassis.
b.
Remove two screws and lockwashers (one from each end of
switch assembly).
Pull switch free of bottom of chassis as far as leads will
c.
permit, then unsolder and tag leads to clearly identify switch sections
and terminals to which they connect.
Remove switch assembly.
d.
NOTE
POWER OFF switch may be individually replaced without
removing switch assembly by unsoldering four leads,
removing one screw, and slipping switch off tang on
switch assembly and installing new switch.
To replace switch assembly, connect leads as tagged in step
e.
Previous Page
