TM 11-5835-241-13&P
washers (at top and bottom of pressure roller).
d.
Lift speed control knob and rotate knob counterclockwise
to remove it from threaded control shaft.
e.
Remove RECORD LEVEL control knob by loosening two setscrews
and lifting knob from shaft, then lift PLAY LEVEL control plate from
shaft.
f. Disconnect plug from record head and place it in slot in
top plate.
Remove two nuts, screws, lock washers, and flat washers (one
g.
at each side of top panel) then lift top panel free of chassis.
h.
Replacement of top panel is essentially the reversal of
removal.
When reconnecting the record head plug, grooved end of plug
must be up toward top of record head.
REMOVAL AND REPLACEMENT OF TAPE DRIVE BELTS.
a.
CAPSTAN DRIVE BELT.
(1) Remove chassis from case (Paragraph 4-3).
(2) From bottom of chassis, slip drive belt off capstan
drive pulley and over capstan drive motor fan blade.
CAUTION
Do not bend capstan drive motor fan blades when
removing drive belt.
(3) Replace capstan drive belt by reversing steps 1 and 2.
b.
COUNTER DRIVE BELT.
(1) Remove chassis from case (Paragraph 4-3).
(2) Remove top panel (Paragraph 5-4).
(3) Slip belt off counter drive pulley, then up through hole
in chassis and over the reel pedestal.
(4) Slip new belt over reel pedestal and down through hole
in chassis.
Previous Page
