TM 32-5835-001-24 & P
(i) Tighten wing screw on base.
(j) Connect cables as shown in figure 2-3.
NOTE
Connector M81511/06EB01P1 and clamp M81511-13-10A are connected to power
supply connector J 1 and terminated as required in the vehicle.
Vehicle Configuration
(3) Shelter.
(a) Place base into assigned area of shelter for installation.
(b) Mark mounting surface through four holesin each resilient mount
(figure 2-1A).
(c) Remove base and drill holes to receive approved shelter hardware.
(d) Remove four resilient mounts from baseplate.
(e) Secure four resilient mounts to shelter mounting surface.
(f) Position baseplate over four resilient mounts and secure.
(g) Attach power supply to recorder (figure 1-1) and secure latches.
(h) Position recorder set on base and secure three latching clips, on
underside of baseplate (figure 2-1).
(i) Tighten wing screw on base.
(j) Connect cable as shown in figure 2-4.
2-4
Previous Page
