TM 32-5835-005-14 & P
OPERATING
INSTRUCTIONS
Section
I.
OPERATORS
CONTROL
AND
INSTRUMENTS
c. Be sure cassette door is open before
3-1. Damage From Improper Settings.
ejecting tape.
a. POWER toggle switch must be in the
3-2. Operator/crew controls.
off position (down) when unit is not in
operation, and before making power
Operating controls, connectors and in-
connections.
b. SEARCH knob is used only in FAST
FWD and REWIND modes of operation. For
normal FAST FWD and REWIND operation,
the SEARCH knob should be fully clock-
Section
II.
OPERATION
UNDER
USUAL
CONDITIONS
(4) Insert new cassette rear first
3-3. Operating
Procedure Mobile/Fixed.
and full reel down. Unit will not op-
erate without a cassette. Operating
The following section provides a de-
without a cassette in the Record or
tailed step-by-step procedure for
Reproduce mode will result in unit
operating the AN/UNH-17A. Refer to
stopping. Do not use prerecorded
test tapes except as specified for
referenced controls. Instructions
maintenance testing.
apply to either mobile or fixed oper-
ation.
(5) Close cassette door and secure
3-4. Preliminary Starting Procedure.
latch.
Perform the following preliminary
(6) Turn function switch to STAND-
starting procedures prior to operating
the equipment.
BY.
(1) Turn latch on cassette door
(7) Check that receiver and micro-
phone connection are correct.
and open.
(2) If a cassette is in the mag-
(8) Set tape counter to 000 by
pressing RESET.
azine, turn function switch to EJECT
and release switch.
(9) Flip POWER ON switch up.
(3) If no cassette is in the mag-
azine, turn function switch directly to
LOAD/UNLOAD.
3-1